Camouflage, an ultra-slim LED Wall Sconce which seamlessly blends in with nature without being noticed. Like the magical effect of a lunar eclipse in a dark sky, Camouflage by Piero Lissoni is surrounded by a circular halo of light.
“Switch off the light and, as if by magic, the lamp disappears. Switch it on and, again as if by magic, all you see is the light itself. Is it a lamp or a chameleon?”
LED power supply source for remote installation, 24V/25W, 120V-277V, PWM Dimming
LED power supply source for remote installation, 24V/45W, 120V-277V, PWM Dimming
LED power supply source for remote installation, 24V/90W, 120V-277V, PWM Dimming
Input fixture voltage 24V
Control: Non Dimmable / Standard 0-10V dimming
Driver: Remote – Class 2
Input Driver Voltage: 120V-277V
Recommended connections for in-ground installations with a 2-way terminal block 4-pole IP68 water stop on 24V side. Order separately (by others)
All drivers should be installed in weather resistant enclosures (by others) or indoors. Silicon filled wire-nuts, should be used on all line-voltage connections to avoid syphoning moisture to electrical components.
Stone finishes are a fiberglass reinforced cement mixture.
The primer version is suitable for paint after installation with any water-based exterior paint or stucco.
The painted versions are an exterior rated epoxy polyester powder coat finish for superior strength, heat and UV resistance.
During installation and maintenance avoid scratching or damaging the finish as it may result in premature corrosion of metal surfaces. Avoid cleaning fixtures with corrosive chemicals as it may result in voiding the warranty.
LED fixtures are highly susceptible to failure due to electrical effects from poor connections, and electrical short circuits. These are frequently caused by (a) over-voltage from primary voltage sources, (b) electrostatic discharge from the exterior environment. Ensure that all outdoor fixtures are installed on GFI circuits as required by code, and use proper surge protecting devices to avoid irreversible damages to electrical components.